The light source of tunnel lighting should meet the requirements of light efficiency, light flux, life span, light color and color rendering under the specific environment of the tunnel, and at the same time, it should ensure good visibility in the smoke caused by automobile emission. The tunnel lighting effect must rely on the reliable light source to achieve. Once the highway tunnel is put into use, the lighting system is almost in the state of long-term lighting under the normal state. Therefore, the selection of an appropriate light source is an important part of tunnel lighting.

Tunnel lighting requirements

Highway tunnel lighting, usually according to the current regulations, the tunnel is divided into population section, transition section, intermediate section and exit section for design, degree and lighting among which there are two transition section, respectively designed before and after the intermediate section.The design of the length of each section is based on the safety requirements of the whole year, and the design of the maximum illumination in the tunnel is to determine the lamp power and distribution density of each section of the tunnel by the maximum brightness and the maximum driving speed outside the tunnel.The realization of automatic lighting control is also very limited, usually due to the limitation of the wiring circuit, can only achieve 2 ~ 3 artificial or automatic control. For parameters such as weather, speed, and vehicle flow, the maximum value is only considered in the design phase.Finally, the length of each section of illumination and illuminance are also always in the maximum state.

Pls check the blew link to see the product detail information:

CYCLOPS SERIES 240W-1800W

Green light LED are suitable for tunnel

Lighting design from three aspects:
1.Solve the problem of the convenience of the circuit board installation and disassemble;
2. For the line, heat, moisture design;
3.The choice of transparent materials.So that the developed lighting can reach the level of safety protection, good heat dissipation, disassemble is more convenient to meet the requirements of use.

Energy saving is money

Energy saving is a way to control the cost of consumption, LED than the traditional energy-saving lamps and lanterns is all know, but the Green light LED can do 30% more energy efficient than regular LED, because we will use less power to reach customers want effect, because need long time order, so can do it with the least amount of lamps and lanterns to achieve the desired effect is the beginning of the energy saving, but it is important to note that the total lumen itself of lamps and lanterns is not necessarily equal efficiency is best used in the designated area.